24/7 Phone Services 0086(371)86151827
Send to E-mail [email protected]
[email protected] Xincheng Science & Technology Building High-Tech Development Zone, Zhengzhou, China

40 in. in diameter storage tank allowable tensile stress value

40 in. in diameter storage tank allowable tensile stress value

40 in. in diameter storage tank allowable tensile stress value

Compared with the common pressure vessel, the pressure parts of the boiler not only bear the pressure, but also suffer from the radiation and erosion of the high temperature flue gas. Once the pressure components of the boiler fail in operation, it will cause extremely serious consequences. Therefore, the 40 in. in diameter storage tank, steel materials used to manufacture the pressure components of the boiler must have enough high strength, plasticity, toughness, fatigue resistance and corrosion resistance, as well as good high-temperature mechanical properties for high-temperature components.

The refrigerated tank primary components shall include, but will not be limited to, the following parts of a single-wall tank or of the inner tank 40 in. in diameter storage tank in a double-wall tank: shell plates; bottom plates; knuckle plates; compression rings; and shell manways and nozzles including reinforcement, shell anchors, piping, tubing, forgings, and bolting. Roof nozzles in contact with the refrigerated liquid shall be considered primary components.

API 650 petroleum storage tank stipulates that if the thickness of the lower siding obtained by calculating the anti-overturning moment is greater than the thickness of the 40 in. in diameter storage tank hydrostatic pressure test (both do not include the corrosion margin), the calculated thickness of the above siding required by the hydrostatic pressure is It should also be increased by the same proportion, unless special analysis is performed to determine the seismic overturning moment and corresponding stress at the bottom of each layer of API 650 petroleum storage tank wall.

The company will rely on its good reputation, excellent hot-rolled plates, steel pipes, 40 in. in diameter storage tank, steel structure products, and intimate after-sales service to customers. I would like to express my heartfelt thanks to the old and new friends and customers who have always given care, support and help to the company! The company sincerely hopes to establish a long-term cooperative relationship with them, mutual benefit and common development. Welcome to come and visit our 40 in. in diameter storage tank steel mill.

Previous : 45 ft in diameter water steel tank extra-strong pipe

Next : 75 ft in diameter API620 oil tank compression-ring girders

Leave a message

Client Image 1
Client Image 2
Client Image 3
Client Image 4
Client Image 5
Client Image 6
Client Image 7
Client Image 8
Client Image 9
Client Image 10
Client Image 11
Client Image 12