24/7 Phone Services 0086(371)86151827
Send to E-mail [email protected]
[email protected] Xincheng Science & Technology Building High-Tech Development Zone, Zhengzhou, China

API650 petroleum and crude oil tanks single-fillet lap joints

API650 petroleum and crude oil tanks single-fillet lap joints

API650 petroleum and crude oil tanks single-fillet lap joints

ASTM A285 grade A standard specification for pressure vessel plates. API650 petroleum and crude oil tanks, carbon steel, low- and intermediate-tensile strength. ASTM A285 grade A plates are normally supplied in the as-rolled condition. The plates may be ordered normalized or stress relieved, or both.Supplementary Technology: HIC Test I NACE MR0175 1 215 | Z25 | 235 | S57 | S57.1| S58 | S58.1 1S3 |S4 Thickness: 6MM to 300MM.Width: 1500mm to 4050mm.
API650 petroleum and crude oil tanks, P355GH steel yield strength in different thickness has different values.Thickness 8-16mm: 355MPa min., >16-40mm: 345MPa min., >40-60mm: 335MPa min., >60-100mm: 315MPa min., >100-150mm: 295MPa min., >150-250mm: 280MPa min. The elongation minimum is 20%. P355GH plate under EN10028-2:2003 standard is a pressure vessel steel. It is always delivered in hot rolling, controlled rolling, normalizing.

API 620 storage tanks relative standard for referenceASTM A106 Seamless Carbon Steel Pipe for High-Temperature ServiceASTM A131 Shipbuilding Structural Steel for API650 petroleum and crude oil tanksASTM A134 Welded Steel PipeASTM A182 Forged or Rolled Alloy-Steel Pipe Flanges, Forged Fittings, and Valves and Parts for High-Temperature ServiceASTM A193 Alloy-Steel and Stainless Bolting MaterialsASTM A194 Carbon and Alloy Steel Nuts for Bolts for High-Pressure and High-Temperature ServiceASTM A213 Seamless Ferritic and Austenitic Alloy-Steel Boiler, Superheater, and Heat Exchanger TubesASTM A240 Stainless Steel Plate, Sheet, and Strip for Pressure VesselsASTM A283 Low and Intermediate Tensile Strength Carbon Steel Plates

The interior of API 650 storage tanks to be internally lined or coated must have all edges rounded to a minimum of 3 mm radius. Internal welds must be completely seal welded, ground smooth, and free from API650 petroleum and crude oil tanks surface porosity, pockets, and high spots. Remove weld spatter. Vendor as specified on API 650 storage tanks drawing must perform additional surface preparation.

Our company has been established for 20 years and has accumulated rich experience in steel products. At the same time, it is often exported to Southeast Asia, Africa, South America and other countries. So you can rest assured that our API650 petroleum and crude oil tanks products and our prices are very favorable. Because we have our own factory, there is no other cost, we can also carry out machining and so on.

Previous : 5 biggest API oil tank companies ultrasonic examination requirements

Next : pressure vessel tank company vertical plane

Leave a message

Client Image 1
Client Image 2
Client Image 3
Client Image 4
Client Image 5
Client Image 6
Client Image 7
Client Image 8
Client Image 9
Client Image 10
Client Image 11
Client Image 12