24/7 Phone Services 0086(371)86151827
Send to E-mail [email protected]
[email protected] Xincheng Science & Technology Building High-Tech Development Zone, Zhengzhou, China

Flour steel silo inspection during the hydrostatic test

Flour steel silo inspection during the hydrostatic test

Flour steel silo inspection during the hydrostatic test

Pressure vessel steel plates are mainly used for manufacturing pressure vessels and other similar equipment for gas separation and gas storage and transportation in petroleum and chemical industry. Generally, the working pressure of pressure vessel steel plates ranges from normal pressure to 320kg / cm2 or even 630kg / cm2, and the temperature ranges from - 20 °C to 450 °C. In addition to certain strength, good plasticity and toughness, pressure vessel steel plates must also have good cold bending and welding properties. Q245R, Q345R, 14Cr1MoR, 15CrMoR, Flour steel silo etc. are common pressure vessel steel grades.

Allowable compressive stresses shall be in accordance with 5.5.4 except that for aluminum alloy plate the allowable compressive stresses shall be reduced by the ratio of the modulus of compressive elasticity to 29,000 for values of (t – c)/R less than 0.0175 and by the ratio of the minimum yield strength for the aluminum alloy in question to 30,000 for values of (t – c)/R equal to or greater than 0.0175 (see 5.5.2 for definitions). In all other equations in this standard Flour steel silo where yield strength or modulus of elasticity is used, such as Equations 27 and 28, similar corrections shall be made for aluminum alloys.

API 650 is an American standard for welding flat bottom vertical storage tanks. This Flour steel silo standard specifies requirements for the design, manufacturing, welding, inspection and installation of storage tanks. API 650 is widely used in storage tanks designed to withstand low internal pressures and used to store typical products such as Flour steel silo crude oil, gasoline, chemicals and water. BBN has extensive experience in API 650 tanks, from +/- 500 cubic meters of tanks produced in the factory to +/- 15000 cubic meters of tanks produced on site

We focus on ensuring that we have a large availability of all hot rolled plate thicknesses and dimensions so that all normal requirements can be met on an ex-stock basis. We also aim to be able to meet requirements for larger quantities that would normally be ordered from the mill in order to help customers in the oil and gas industries to accelerate deliveries times of their projects.

Previous : Feed steel silo the roof and cylindrical sidewall

Next : Grain and oil steel silo inner tank tolerances

Leave a message

Client Image 1
Client Image 2
Client Image 3
Client Image 4
Client Image 5
Client Image 6
Client Image 7
Client Image 8
Client Image 9
Client Image 10
Client Image 11
Client Image 12