24/7 Phone Services 0086(371)86151827
Send to E-mail [email protected]
[email protected] Xincheng Science & Technology Building High-Tech Development Zone, Zhengzhou, China

Hydrogen buffer storage tank bottom-to-shell joint

Hydrogen buffer storage tank bottom-to-shell joint

Hydrogen buffer storage tank bottom-to-shell joint

The technology center has always been focusing on application research, improving market realization and scientific and technological contribution rate; taking user demand as the goal, highlighting the personalized development of products; taking the joint development of industry, University and research, and technology integration as the means, improving the starting point and level of innovation, and realizing the breakthrough of core technology; taking advanced research as the guide, pursuing the leap of technological development.

Thickness as it Affects Preheat and Post-heat Requirements
Plate with thicknesses below 1/2 in. is reasonably notch tough. In most steels, when the Hydrogen buffer storage tank used plate thickness exceeds 3/4 in. – 1 in., notch toughness, particularly as welded, decreases sharply. The decrease in notch toughness can be minimized by the conventional post-heat treatment and, in many steels, by preheat treatment. The benefits of preheat treatment in steels 3/4 in. – 1 in. thick have been demonstrated; similar benefits could be expected in thicker steels, but sufficient experimental data are currently lacking.

The cone slope of the completed Hydrogen buffer storage tank foundation is 15/1000 for the general foundation and less than 35/1000 for the soft foundation. After the foundation settlement of the storage tank is basically stable, the surface slope must be greater than eight thousandths. The edge of the tank bottom should be more than 0.3 meters higher than the surrounding ground. Above the ground, the tank bottom leakage detection tube should be drawn from the foundation sand cushion and cross the foundation ring wall or the slope protection surface. The circumferential distance should be less than 20 meters, and each Hydrogen buffer storage tank should have at least 4 detection tubes.

Our company stocks a wide range of hot rolled steel plate distributed globally from our service centers in the U.S., Canada, Mexico, U.K, France, Shanghai, and Singapore. Customers calling for Hydrogen buffer storage tank a lot of times are also trying to get their arms around forecast issues. As our customers continue to work on their forecasts, IRON & Steel has options to help you conduct structured forecast reviews and put inventory strategies in place to effectively manage any impact from forecast variability.

Previous : Fuel storage tank 62 ft 6 in. in diameter

Next : Gasoline storage tank shop stress relief

Leave a message

Client Image 1
Client Image 2
Client Image 3
Client Image 4
Client Image 5
Client Image 6
Client Image 7
Client Image 8
Client Image 9
Client Image 10
Client Image 11
Client Image 12