24/7 Phone Services 0086(371)86151827
Send to E-mail [email protected]
[email protected] Xincheng Science & Technology Building High-Tech Development Zone, Zhengzhou, China

LNG tank for oil and gas industry design of compression-ring regions

LNG tank for oil and gas industry design of compression-ring regions

LNG tank for oil and gas industry design of compression-ring regions

A517 Grade Q steel is a low-alloy pressure vessel grade rolled steel plate that conforms to A20 manufacturing specifications; in an open-hearth under oxygen or via electric arc production. These plates have a maximum thickness of 32mm LNG tank for oil and gas industry and must be subjected to robust heat analysis to verify its elemental composition. Process managers must carefully control the levels of carbon, manganese, phosphorous, sulfur, silicon, chromium, molybdenum, boron, vanadium, and titanium in order to guarantee compliance – thus performance.

Proof Tests for Establishing Allowable Working PressuresBecause pressures in liquid storage tanks built according to these rules vary quite markedly from the tops to the bottoms of the tanks, proof testing of these tanks presents problems not usually encountered in the construction of unfired pressure vessels–especially where the LNG tank for oil and gas industry parts under investigation are located near the bottoms of the tanks. The principal difficulty is devising a test or series of tests that will reliably establish the working pressure that can be permitted on the part of the unproven design without, at the same time, imposing hazardous conditions on other parts located at higher levels in the tank.

API 650 petroleum storage tank has the advantages of high safety: the LNG tank for oil and gas industryinner floating plate floats on the liquid surface, so that the liquid phase has no evaporation space, which can reduce the evaporation loss by 85% to 90%. At the same time, the API 650 petroleum storage tank blocks the air and liquid storage through the floating disk, which reduces air pollution and reduces the degree of fire risk.

Our company has been established for 20 years and has accumulated rich experience in steel products. At the same time, it is often exported to Southeast Asia, Africa, South America and other countries. So you can rest assured that our LNG tank for oil and gas industry products and our prices are very favorable. Because we have our own factory, there is no other cost, we can also carry out machining and so on.

Previous : LNG containment and insulation systems roof-supporting structural members

Next : LNG oil transportation pressure vessel matching plates

Leave a message

Client Image 1
Client Image 2
Client Image 3
Client Image 4
Client Image 5
Client Image 6
Client Image 7
Client Image 8
Client Image 9
Client Image 10
Client Image 11
Client Image 12